How to get rid of dampness in the drying room?
Language
Helske

How to get rid of dampness in the drying room?

The room where the laundry is dried is usually very damp. This can result in the formation of mold that can also spread to clothes dried there. 

Get rid of excess moisture in the drying room by using the Nano Coat System, which was developed using a top-notch nanotechnology.

Our active material addresses dampness and humidity in the drying room. When applied on the walls, the material creates a thermo- reflective layer that reflects the heat back into the room, while also allowing water to vaporize. The material removes excess humidity to prevent mold formation. The material also prevents dampness from forming on the walls and ceilings, so the walls can breathe. Nano Coat System is a hypoallergenic product with antibacterial surface. Therefore, the Nano Coat System is the ideal solution for drying rooms where clothes are being dried.



On which parts of the drying room should the material be applied?

You can apply the system to all room walls, including the ceiling, all peripheral (facade, exterior) walls or to places where thermal bridges are located.

Thanks to the combination of Nano Coat System and regular ventilation, you can significantly reduce the humidity in the drying room.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.
 

Apply in the following order: 

 1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM