How to get rid of dampness in the office?
Language
Helske

How to get rid of dampness in the office?

Dampness in the office increases the risk of mold formation. Mold is dangerous to our immune system. Those suffering from allergies should avoid being in the room infested with mold.

Get rid of excess humidity and dampness in the office and prevent the formation of unpleasant molds with Nano Coat System – a unique material developed using nanotechnology.

Our active material addresses dampness and humidity in the office. When applied on the walls, the material creates a thermo-reflective layer that reflects the heat back into the room, while also allowing water to vaporize. The material removes excess humidity to prevent mold formation. The room heats much faster thanks to the material. The material also prevents dampness from forming on the walls and ceilings, so the walls can breathe.



On which parts of the office should the material be applied?

You can apply the system to all room walls, including the ceiling, all peripheral (facade, exterior) walls or to places where thermal bridges are located.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

 1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM