How to get rid of mold in the drying room
Language
Helske

How to get rid of mold in the drying room

Mold is formed due to excessive dampness. Mold releases into the air spores which we then breathe in. As a result, people may suffer from various diseases. Mold thrives in places with irregular and insufficient ventilation. Mold can occur on facade walls, thermal bridges, and around windows, it can also land on the clean linen and clothes.

You can prevent mold formation by using the Nano Coat System, a special active building material developed by modern nanotechnology.

Nano Coat System creates a thermo-reflective layer that reflects heat back into the room while removing excess dampness and humidity. The material prevents water vapor condensation on the surfaces. Thanks to its high porosity and breathability, it ensures optimum humidity levels in the interior. Thanks to Nano Coat System the room is heated much faster. In addition, the surface of the material is antibacterial and prevents mold formation.



On which parts of the drying room should the material be applied?

Apply Nano Coat System to all peripheral (facade, exterior) walls and places where thermal bridges are located, around the windows and balcony doors, behind furniture as the air flow is poor there
and water condensates there more often than at other places. Do not forget about the walls behind the furniture, because the ventilation there is poor, resulting in the formation of mold.

If your walls are already infested by mold, it is important first to get rid of it and repair the wall construction, and only then apply the material.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Home the final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM