How to get rid of mold in the wardrobe?
Language
Helske

How to get rid of mold in the wardrobe?

Wardrobe is a risky room as dampness in there can cause mold. Mold can spread to clothes we wear every day. The risk of mold formation is high because the mold is doing great in poorly ventilated areas without air flow. As the wardrobe is filled with clothes and often without windows, regular ventilation is sometimes impossible. Therefore, mold can form on the walls, but also in the cabinets.

Mold can be prevented by applying the special material Nano Coat System developed using patented nanostructured technology.

Active building material creates a thermo-reflective layer that reflects heat back into the room while removing excess dampness and humidity. The material prevents water vapor condensation on the surfaces. Thanks to its high porosity and breathability it ensures optimum humidity levels in the interior. In addition, the surface of the material is antibacterial – ideal for wardrobe.



On which parts of the wardrobe should the material be applied?

Apply Nano Coat System to all walls and the ceiling of the bedroom. Alternatively, you can apply the material to all peripheral (facade, exterior) walls and places where thermal bridges are located, around the windows and balcon doors.

If your walls are already infested by mold, it is important first to get rid of it and repair the wall construction, and only then apply the material.

A combination of Nano Coat System, regular ventilation and at least 10 -15 cm space between furniture and the wall can effectively prevent mold formation.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.


 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM