How to make wardrobe less hot during summer?
Language
Helske

How to make wardrobe less hot during summer?

High temperatures have a negative effect on the clothes you have often stored up to the wardrobe’s ceiling. In summer, the sun rays warm up the walls of the room which can then become really hot. If the wardrobe is placed in a corner room, the heat fromt the roof also contributes to the overall hotness. 

To mitigate the heat in the wardrobe try applying our Nano Coat System developed using a special nanotechnology.

The exceptional properties of the material regulate the microclimate in the room and maintain a pleasant room temperature. Heat is evenly distributed throughout the room, thus creating a heat shield that absorbs heat. The walls thus do not heat so much.



On which parts of the wardrobe should the material be applied?

Apply the Nano Coat System to the perimeter (facade, exterior) walls or to the places where thermal bridges are located. In these places, the material acts as a copper tube into which we pour boiling water - one end is covered with a 2 mm Nano Coat System (to hold the tube) and the other end features a valve. At the place where we used the Nano Coat System, we can actually touch the copper tube as it is not hot at all and maintains a stable temperature. In places where we did not apply Nano Coat System on the copper tube, the temperature would reach around 80 °C! Surely not a surface you would like to touch.

For better effect, apply the material to all the walls and the ceiling of the wardrobe.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM