How to prevent humidity in the laundry room?
Language
Helske

How to prevent humidity in the laundry room?

The laundry room is a room with increased humidity levels due to steam coming out of a washing machine and dryer. The laundry room is usually poorly heated and insufficiently ventilated. In addition, the risk of mold infestation increases with high humidity levels. You can get rid of excess humidity in the laundry room using the Nano Coat System.

Thanks to the special compound developed using the state-of-the-art nanotechnology, you can effectively address the humidity problem. When applied on the walls, the material creates a thermo-reflective layer that reflects the heat back into the room, while also allowing water to vaporize. The material removes excess humidity to prevent mold formation. The material also prevents water condensation from forming on the walls and ceilings, so the walls can breathe. Nano Coat System is a hypoallergenic product with antibacterial surface. Therefore, the Nano Coat System is the ideal solution for laundry room where bed linen and clothes are being treated.



On which parts of the laundry room should the material be applied?

Apply Nano Coat System to all walls and the ceiling of the laundry room. Alternatively, you can apply the material to all peripheral (facade, exterior) walls, to places where thermal bridges are located, around the windows and scuntion, as well as to the walls around the washing machine or dryer. Thanks to the combination of Nano Coat System and regular ventilation, you can significantly reduce the humidity level in the laundry room.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM