How to Save on Heating Large Areas in an Open-plan Living Room and Kitchen
Language
Helske

How to Save on Heating Large Areas in an Open-plan Living Room and Kitchen

Large, open-plan spaces in the flat or house, such as a living room combined with the kitchen, are difficult to heat up. Heating time is long and energy costs are higher. If one of the walls is a circumferential (façade) wall and there are thermal bridges, windows or a balcony, on it, problems may arise.

The application of the Nano Coat System active substance can influence several factors at once.

The Nano Coat System material was specially developed by the Helske company based on the principle of nanotechnologies. It creates a thermal reflective layer on the walls which reflects thermal radiation back to the room. This reduces the required heating time. In addition, if you apply the building material behind the radiators or heaters, you can save even more because of the reflection of the heat. Heat usually escapes through these problematic places - the walls are heated in vain. In this way, combined with proper insulation, you can save even 35% on energy annually, with respect to heating as well as cooling.

At the same time, the Nano Coat System is an efficient form of anti-mould prevention. It is designed to permeate moisture, reducing the risk of the formation of moulds and the development of allergies. The material is warm to the touch and retains its high brightness. In this way, you can create a lasting ideal microclimate in the open-plan living room quite simply and at no great expense.



Which Places Should the Material be Applied to in the Living Room?

Apply the Nano Coat System behind the radiators to reflect the heat back to the room and prevent its escape through the walls. Apply it also to the reveals around the windows and the entrances to the balcony because these are the places where heat escapes and water vapours condense, which can be prevented by the Nano Coat System. Apply it also to all the circumferential walls (façade, external walls) or to the places where thermal bridges are present.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

 1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM