How to Treat the Ceiling in the Kitchen to Prevent Heat Loss and Increased Humidity
Language
Helske

How to Treat the Ceiling in the Kitchen to Prevent Heat Loss and Increased Humidity

Cooking increases the humidity in the kitchen areas and water vapours condense on the surface of the walls. This is accompanied by regular ventilation and consequent heat loss. You should bear these problems in mind when reconstructing your kitchen and take preventive measures.

Treat the walls with the Nano Coat System and eliminate the risk of heat loss and that of the appearance of moulds in the very beginning.

The Nano Coat System has been developed with special technology based on nanostructures. This permeable material ensures the natural breathing of the walls and enables the passage of water vapour through the structure and the ceiling. At the same time, it prevents the condensation of water vapours on the surface of the walls, reducing the risk of the appearance of moulds. The system is suitable to all the rooms where food is present, since it complies with the EU requirements for the certification of food contact materials and has an antibacterial surface. It also absorbs the odours produced during cooking.

By applying the Nano Coat System to the kitchen ceiling, you can prevent undesirable heat loss. Thanks to the transmission of heat between the molecules and its distribution over the whole area of the ceiling, a thermal shield is formed, which permeates vapour and reflects heat back to the room.



Which Places Should the Material be Applied to in the Kitchen?

The system can be applied to all the walls of the kitchen. We recommend applying it to the ceiling as well, to prevent heat loss through the structure. Another advantage of the system is its applicability to non- absorbent surfaces, such as wall tiles, floor tiles, marble, glass etc.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.



 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

S_text1
S_text2
S_text3