Mould in Children’s Bedrooms: How to Get Rid of It in the Corners of the Room?
Language
Helske

Mould in Children’s Bedrooms: How to Get Rid of It in the Corners of the Room?

Mould can cause several diseases which are dangerous for children. Children’s bedrooms are the places where the children spend most of their days and nights, so it is important to create a healthy environment in their rooms. Moulds appear in the corners of the room because of the thermal bridges, i.e. places in which heat from the interior passes faster to the exterior compared to the other places of the building or structure. Thermal bridges are present e.g. in corners, niches, or caps. In these places, water vapour condenses on the surface and temperature drops, which results in the appearance of moulds.

Eliminate these thermal bridges to prevent the appearance of moulds in the corners of your child’s room. The Nano Coat System, an active building material developed by state-of-the-art technology based on nanostructures, helps you achieve this.

Its qualities eliminate thermal bridges and  reduce humidity in the bedroom. It prevents the condensation of water vapours on the surface and reduces heat loss. It creates a thermal reflective layer on the walls, which reflects thermal radiation back to the room but reduces excessive moisture, reducing the risk of the appearance of moulds.



Which Places Should the Material be Applied to in Children’s Bedrooms?

Apply the Nano Coat System to the places where thermal bridges are present. These are places where heat from the interior passes faster to the exterior compared to the other places of the building. Apply it around the windows and balcony doors, too, because water vapours may condense in these places.

If your wall is already affected by moulds, the most important thing is to get rid of them and to do the necessary repairs to the structure of the wall; apply the building material only subsequently.


Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.


Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM