Moulds in Loft Rooms: How to Get Rid of Them in the Corners of the Room and on the Ceiling?
Language
Helske

Moulds in Loft Rooms: How to Get Rid of Them in the Corners of the Room and on the Ceiling?

Moulds appear in the corners of loft rooms because of the thermal bridges, i.e. places in which heat from the interior passes faster to the exterior compared to the other places of the structure. Thermal bridges are present e.g. in corners or various caps.In these places, water vapour condenses on the surface and temperature drops, which results in the appearance of moulds.

The Nano Coat System building material, developed with special patented technology based on nanostructures, can help you eliminate the thermal bridges.

This special mixture prevents the condensation of water vapours on the surface and reduces heat loss through the thermal bridges. It creates a thermal reflective layer on the walls, which reflects thermal radiation back to the room but reduces excessive moisture, reducing the risk of the appearance of moulds. It eliminates the cold spots on the walls and actively regulates the climate in the room.



Which Places Should the Material be Applied to in the Loft?

Apply the Nano Coat System especially to the ceiling, to the thermal bridges, and to the walls adjacent to the exterior. If your wall is already affected by moulds, the most important thing is to get rid of them and to do the necessary repairs to the structure of the wall; apply the building material only subsequently.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home.

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM