Solution: How to Prevent the Appearance of Moulds around the Appliances in the Kitchen?
Language
Helske

Solution: How to Prevent the Appearance of Moulds around the Appliances in the Kitchen?

With baking in the oven, heating food in the microwave or boiling water in the electric kettle, the overall humidity of the kitchen increases. Especially the walls around the appliances are prone to higher moisture which leads to the condensation of the water on their surface and, quite frequently, to the appearance of moulds. Healthwise, moulds are very dangers because they release spores into the air, which cause respiratory problems, allergic reactions or skin diseases.

Treat the walls as a preventive measure and eliminate the risk of the appearance of moulds in the very beginning. The solution is to apply the Nano Coat System building material.

This active building material has been developed with special technology based on nanostructures. This permeable material ensures the natural breathing of the walls and enables the passage of water vapour through the structure. At the same time, it prevents the condensation of water vapours on the surface of the walls, reducing the risk of the appearance of moulds. The system is suitable to all the rooms where food is present, since it complies with the EU requirements for the certification of food contact materials and has an antibacterial finish. Also, it absorbs the odours produced during cooking or baking. 




Which Places Should the Material be Applied to in the Kitchen?

The system can be applied to all the walls of the kitchen, including the ceiling. We recommend applying it also around the household appliances to prevent the condensation of the water on the surface of the walls and eliminate the risk of the appearance of moulds. Another advantage of the system is its applicability to non- absorbent surfaces, such as wall tiles, floor tiles, marble, glass etc.

Nano Coat System consists of: 

Nano PT - represents deep penetration that stabilizes the foundations. It is used for absorbent cohesive surfaces and is applied with a brush or roller.

Nano AM - it is used on all other surfaces where we can not use Nano PT. Thus, non-absorbent cohesive surfaces such as glass, iron and others. Apply with a brush or roller.

Nano TC - it is used to repair holes, cracks and small irregularities of size up to 3-4mm.

Nano Coat Homethe final layer of mass applied by a stainless comb trowel to a pre-treated, smooth surface of about 2 mm thick. After drying, grind the surface with sandpaper.

 

Apply in the following order: 

1. Nano PT or Nano AM,

2. Nano TC, if necessary to repair the surface,

3. final layer Nano Coat Home

 

RECOMMENDED

Get In Touch!

YOUR CONTACT FOR QUESTIONS ABOUT HELSKE ENERGY SAVE®:

CCS@HELSKE.COM